AMR300 Receiver

AMR300 Communications Receiver 1945

Click to view Circuit in a new window.

General Description

The AMR300 was one of 3 groups of receivers developed by STC, Sydney, Australia, for the armed services during WW2. The original receivers were identified as A679, usually A679-H, A679-J and A679-K.

These sets in the first instance were designed and manufactured for the R.A.N. and R.A.A.F. The differences in type numbers reflected changes to cater for a variety of different applications.

The general purpose receiver covered 1.5 - 24 MHz in 4 bands. These were 1.5 - 3.0, 3.0 - 6.0, 6.0 - 12.0 and 12.0 - 24.0 MHz.

The identifier AMR300 did not come into being until 1945 when the US services required a HF communications receiver - this set improved on the previous models and included temperature compensation of the local oscillator and Faraday screens to enable the set to be used successfully with direction finding systems.


Technical Data

The set had a sensitivity of 2 microvolts. AMR300 plate

The valve line-up is as follows:
V16U71st RF Amp
V26U72nd RF Amp
V36K8Frequency Converter
V46U71st IF Amp
V56G82nd IF Amp and 2nd Detector
V66B8Audio Amp
V76V6Audio Output
V86J7BFO
V95V4Rectifier

The IF frequency is 455kHz. In its original form, the audio output was 40mw into 5000 ohms connected across one phone jack and 2 watts at 600 ohms across the line terminals.

The oscillator stability is, after 10 minutes warm up, less than 0.05% of the operating frequency on any range.

The sets were designed to operate from either 240 or 110v AC (62 watts), while a separate vibrator supply was available for 12 volt DC operation.

The set weighs 74lbs, appx 34 kg.

The HT line at the output tube was appx 230v dc, with 215v ac being applied to the plates of the rectifier.

The receiver was in high demand by radio amateurs and short wave listeners after the war and commanded high purchase prices from disposal outlets. Unlike other sets of similar performance produced during this period, the AMR300 series did not use plug in coil boxes, which made them easier to use and somewhat tidier!


Illustrations of the set

AMR300 Top view AMR300 bottom view


Back to Top or Go to Home page.

© Ian O'Toole, 2009. Page created: 01/07/03 Last updated: 27/10/2012