Overview

This folder contains Programming files for the Icom ID-5100 Plus

Release: Generated on 2018-10-25 with WIA data from 180803

The files were prepared using the Icom CS-5100 software V 1.2 with Data extracted from the WIA data set.
1000 Memories

Files

• Configuration
  • [s3secureurl bucket=’warssharedfiles’ target=’/public/ICOM/ICOM_5100_12/5100_12_VK2BV.icf’ expires=’25’]5100_12_VK2BV.icf[/s3secureurl] – most recent icom file

This file was built for a ID-5100A using the CS-5100 Version 1.2 and Firware E3.

• Build Files to create standard configuration
  • [s3secureurl bucket=’warssharedfiles’ target=’/public/ICOM/ICOM_5100_12/IcomDStarplus.zip’ expires=’25’]IcomDStarplus.zip[/s3secureurl] – Output from the repeater configuration
    • icombankX.csv, icom6X.csv, icommemX.csv

Radio Load Steps

• Steps to Load the config
• Create the directory structure on an SD card if you haven’t already.
  • Insert and format an SD card in the radio.
  • Menu>SD Card>Save Setting>New File>
    This will create the folders and a backup file.
• Copy the new configuration to the card
  • Power off handset and unload card, insert into PC.
  • The file just created will be ID-5100/Setting/setyyyymmdd.icf
  • Copy the file 5100_12_VK2BV.icf onto the SD
  • Eject the card and load to radio.
  • Menu>SD Card>Load Setting> 5100_12_VK2BV.icf
    • Except My Station (If your radio already has a setup)
    • Keep Skip Yes
    • Load Yes
  • Reset Radio (Power on/off)
• Configure your radio

NOTE: I need acces to a 5100 to update this section so this is probably not correct

• Enable BANK mode on VFO A and B
  • Choose VFO A (short press om MAIN to swap)
  • Press M/CALL to get to MR (memory) mode.
  • Press Quick then select Bank Select > B:SYDCBD
  • The VFO will wrap around the memories in Bank B (about 45)

  • Repeat for VFO B

    The radio is now ready to operate in Bank mode on both VFO’s

  • Change back to VFO A
  • change to [DR] "Digital Mode" and adjust TO and FROM values
    • To – change from "Local CQ" to "Your Call Sign" "Use Repeater"
    • From – test near repeater.

Structure of entries

The ID-5100 supports 2 VFO’s ‘A’ and ‘B’ with 1 Tranceivers. Both VFO’s can process D-Star. Memories and banks are available to both VFO’s.

• In most sections entries are sorted by Callsign

• The ID-5100 supports 26 "Banks" (A-Z), a Memory can only be assigned to 1 bank.

  - A DStar entries
  - B SYDCBD Stations within 60km of Sydney
  - C VK2 South Coast
  - D VK2 North Coast
  - E VK1 and 2 West
  - F WICEN
  - G MEL within 80km of Melbourne
  - H VK3
  - I VK4SE within 80 km of Tamborine
  - J VK4
  - K VK5-8
  - L VK6
  - M VK7
  - N APRS including AU and ISS and other countries
  - O Test
  - X Marine